Photographs have been adapted for the website; dimensions may vary.
Reference Washing Machine (Wascator)
Referans Çamaşır Makinesi (Wascator)
Standard reference washing machine FOM 71 CLS.
Model technical data
- Control: microprocessor-based programmable reference washing.
- Programme capacity: 99 programmes.
- Programming: on the machine or using an external computer.
- Main body and wash drum are stainless steel.
- The reference washing procedure is defined with machine model, load and detergent.
Physical specifications and utilities
| Electrical supply | Approx. 380–415 V AC, 50 Hz, three phase; 60 Hz is a separate build option. |
|---|---|
| Power / connected load | Approx. 5000–7000 W connected load for preliminary planning. |
| Overall instrument dimensions | Approx. 750 × 750 × 1350 mm (W × D × H). |
| Instrument weight | Approx. 180–240 kg net. |
| Gross / shipping weight | Approx. 223–325 kg gross; estimated packing allowance. |
| Lab requirements | Water supply and drain; hot water, water quality and plumbing capacity depend on order configuration. |
Dimension order and approximate values are stated in each row. Packaging data are separate from instrument dimensions and net mass. Approx. rows are preliminary engineering estimates based on comparable equipment and function/capacity; they are not verified manufacturing measurements or standard requirements. Installation and shipment are finalised against the approved drawing and nameplate. Estimate scope: base product / one unit; external computer, bench and auxiliary plant excluded.
Specifications, dimensions, and power requirements are approximate and subject to change without prior notice for continuous design improvements.
Product technical specifications and images may vary according to manufacturing conditions and applicable standards.
Test and configuration
- Measured output / function
- Dimensional change after controlled washing (%)
- Parameters selected for the method
- Machine type, programme, load, ballast and detergent
- Verification points
- Water volume, temperature, drum action and timing
Listed methods are application references. Suitability is established by assessing the selected hardware, current method and calibration together.
Test parameters for the reviewed method
Values belong to the stated source edition. Test recipe, fixture and delivered instrument configuration are selected together.
AATCC 135-2004 · 5.8, 6.2, 9
- Dimensional change includes the option of three 250 mm length and width benchmark pairs on a 380 × 380 mm specimen. Measurement step 0.5% or smaller; change is 100 × (final - initial)/initial, with shrinkage negative. Match machine type/program separately to the edition.
ISO 6330:2012 / TS EN ISO 6330:2012 · 5.1–5.2, 5.6, 6.1.1
- Distinguish washer A horizontal/front-loading, B vertical/agitator and C vertical/pulsator. Match dryer type, ballast and detergent; this edition restricts reference detergent 1 to type B. Record machine type and program edition before assuming method equivalence.
Control and recording specification
The following are method-specific software/recording requirements; delivered software modules are defined by the order scope.
- Method code and edition, specimen ID, operator and selected test parameters are linked to the record.
- Dimensional change (%) = 100 × (final - initial dimension) / initial dimension; direction and sign convention are stated in the report.
- Raw measurements, units, valid/invalid test flags and the reported result remain traceable.
- Calculations are checked against known inputs and an independent calculation; sensor channels are checked against calibration values.
Test standards
Prices start from €18. Request the technical specification and a quotation for this instrument.
Request a quoteCall usPDF catalogue
