Photographs have been adapted for the website; dimensions may vary.
Fabric Drape Tester
Kumaş Dökümlülük (Drape) Test Cihazı
Drape coefficient measurement of fabrics.
Model technical data
- The drape coefficient is calculated by digitally scanning the shadow of the fabric.
- Computer controlled; the software is supplied with the instrument.
- Approximate overall dimensions: 500 × 500 × 500 mm.
- Approximate instrument weight: 19 kg.
Physical specifications and utilities
| Electrical supply | Approx. 220–240 V AC, 50/60 Hz, single phase; build-dependent. |
|---|---|
| Power / connected load | Approx. 20–80 W connected load for preliminary planning. |
| Overall instrument dimensions | Approximate overall dimensions: 500 × 500 × 500 mm. |
| Instrument weight | Approximate instrument weight: 19 kg. |
| Gross / shipping weight | Approx. 30.9–33.8 kg gross; estimated packing allowance. |
| Lab requirements | Level, stable working surface; specimen conditioning follows the selected method. |
Dimension order and approximate values are stated in each row. Packaging data are separate from instrument dimensions and net mass. Approx. rows are preliminary engineering estimates based on comparable equipment and function/capacity; they are not verified manufacturing measurements or standard requirements. Installation and shipment are finalised against the approved drawing and nameplate. Estimate scope: base product / one unit; external computer, bench and auxiliary plant excluded.
Specifications, dimensions, and power requirements are approximate and subject to change without prior notice for continuous design improvements.
Product technical specifications and images may vary according to manufacturing conditions and applicable standards.
Test and configuration
- Measured output / function
- Drape coefficient derived from shadow projection (%)
- Parameters selected for the method
- Specimen diameter, support disc and shadow assessment
- Verification points
- Support/specimen areas and optical geometry
Listed methods are application references. Suitability is established by assessing the selected hardware, current method and calibration together.
Test parameters for the reviewed method
Values belong to the stated source edition. Test recipe, fixture and delivered instrument configuration are selected together.
ISO 9073-9:1995 · 5.1.1 / 5.2 / 5.4
- Support disc: 18 cm diameter; circular specimen templates: 24, 30 and 36 cm.
- Auxiliary balance for the paper-mass method: weighing to 0.01 g.
Control and recording specification
The following are method-specific software/recording requirements; delivered software modules are defined by the order scope.
- Method code and edition, specimen ID, operator and selected test parameters are linked to the record.
- Drape (%) = 100 × (shadow area - support area) / (specimen area - support area).
- Raw measurements, units, valid/invalid test flags and the reported result remain traceable.
- Calculations are checked against known inputs and an independent calculation; sensor channels are checked against calibration values.
Test standards
Prices start from €18. Request the technical specification and a quotation for this instrument.
Request a quoteCall usPDF catalogue
