Photographs have been adapted for the website; dimensions may vary.
Fabric GSM Calculation Kit
Kumaş Gramaj Aleti ve Hesaplama Kiti
GSM kit with circular cutter and precision balance.
Model technical data
- Standard kit: 100 cm² circular sample cutter, digital balance, cutting pads and spare blades.
- Other cutting areas are separate model options.
Physical specifications and utilities
| Electrical supply | Approx. low-voltage adapter with 100–240 V AC, 50/60 Hz input; output voltage is build-dependent. |
|---|---|
| Power / connected load | Approx. 5–20 W connected load for preliminary planning. |
| Overall instrument dimensions | Approx. 350 × 350 × 200 mm (W × D × H). |
| Instrument weight | Approx. 3–7 kg net. |
| Gross / shipping weight | Approx. 5.3–10.8 kg gross; estimated packing allowance. |
| Lab requirements | Level, stable working surface; specimen conditioning follows the selected method. |
Dimension order and approximate values are stated in each row. Packaging data are separate from instrument dimensions and net mass. Approx. rows are preliminary engineering estimates based on comparable equipment and function/capacity; they are not verified manufacturing measurements or standard requirements. Installation and shipment are finalised against the approved drawing and nameplate. Estimate scope: base product / one unit; external computer, bench and auxiliary plant excluded.
Specifications, dimensions, and power requirements are approximate and subject to change without prior notice for continuous design improvements.
Product technical specifications and images may vary according to manufacturing conditions and applicable standards.
Test and configuration
- Measured output / function
- Specimen preparation for mass per unit area (g/m²)
- Parameters selected for the method
- Cutting area, balance resolution and sampling
- Verification points
- Cutting area and traceable balance check
Listed methods are application references. Suitability is established by assessing the selected hardware, current method and calibration together.
Test parameters for the reviewed method
Values belong to the stated source edition. Test recipe, fixture and delivered instrument configuration are selected together.
ISO 3801:1977 · 4.4-4.5
- Small-specimen method: 10 × 10 cm template or 100 cm² circular cutter with 1% area accuracy; balance capable of weighing to 0.001 g. Method and specimen area are stored with the mass-per-area calculation.
ASTM D3776-96 · 1.2, 5.1–5.2
- Distinguish full-piece, full-width, small-swatch and narrow-fabric options. Balance capacity/sensitivity must support weighing within ±0.1% of specimen mass. With a cutter, retain actual cut area, mass and calculated g/m².
Control and recording specification
The following are method-specific software/recording requirements; delivered software modules are defined by the order scope.
- The need for integrated software depends on the method and selected hardware; manual instruments use an external test record.
- Method code and edition, specimen ID, operator and selected test parameters are linked to the record.
- Mass per unit area = specimen mass / area; for a 100 cm² specimen, g/m² = mass in grams × 100.
- Raw measurements, units, valid/invalid test flags and the reported result remain traceable.
- Calculations are checked against known inputs and an independent calculation; sensor channels are checked against calibration values.
Test standards
Prices start from €18. Request the technical specification and a quotation for this instrument.
Request a quoteCall usPDF catalogue
