Photographs have been adapted for the website; dimensions may vary.
Leather Rub Fastness Tester
Deri Sürtme Haslığı Test Cihazı
Carries out a rub fastness test on the leather surface to determine the amount of marring of the surface or finish and to assess colour transfer from the specimen to the rubbing pad. Fastness is assessed by checking the colour change of the specimen and the staining of the felt after rubbing.
Model technical data
- Carries out a rub fastness test on the leather surface, assessing surface marring and colour transfer to the felt.
- Fastness is assessed by checking the colour change of the specimen and the staining of the felt after rubbing.
- It has a memory function and both dry and wet tests can be performed.
- It has a touch screen control panel.
Physical specifications and utilities
| Electrical supply | Approx. 220–240 V AC, 50/60 Hz, single phase; build-dependent. |
|---|---|
| Power / connected load | Approx. 50–150 W connected load for preliminary planning. |
| Overall instrument dimensions | Approx. 650 × 450 × 400 mm (W × D × H). |
| Instrument weight | Approx. 20–40 kg net. |
| Gross / shipping weight | Approx. 32–60 kg gross; estimated packing allowance. |
| Lab requirements | Level, stable working surface; specimen conditioning follows the selected method. |
Dimension order and approximate values are stated in each row. Packaging data are separate from instrument dimensions and net mass. Approx. rows are preliminary engineering estimates based on comparable equipment and function/capacity; they are not verified manufacturing measurements or standard requirements. Installation and shipment are finalised against the approved drawing and nameplate. Estimate scope: base product / one unit; external computer, bench and auxiliary plant excluded.
Specifications, dimensions, and power requirements are approximate and subject to change without prior notice for continuous design improvements.
Product technical specifications and images may vary according to manufacturing conditions and applicable standards.
Test and configuration
- Measured output / function
- Staining grade of rubbing cloth after rubbing
- Parameters selected for the method
- Rubbing head, load, motion and wet/dry condition
- Verification points
- Force, stroke, counter and reference cloth
Listed methods are application references. Suitability is established by assessing the selected hardware, current method and calibration together.
Test parameters for the reviewed method
Values belong to the stated source edition. Test recipe, fixture and delivered instrument configuration are selected together.
EN ISO 11640:1998 / TS EN ISO 11640:2001 · 4.1.2-4.1.3
- Rubbing-foot base 15 × 15 mm; finger mass 500 ± 25 g plus a 500 ± 10 g additional load. Reciprocating travel 35-40 mm at 40 ± 2 cycles/min.
Control and recording specification
The following are method-specific software/recording requirements; delivered software modules are defined by the order scope.
- The need for integrated software depends on the method and selected hardware; manual instruments use an external test record.
- Method code and edition, specimen ID, operator and selected test parameters are linked to the record.
- The calculation and endpoint are defined by the selected method edition; instrument signals and operator assessments are kept distinct.
- Raw measurements, units, valid/invalid test flags and the reported result remain traceable.
- Calculations are checked against known inputs and an independent calculation; sensor channels are checked against calibration values.
Test standards
Prices start from €18. Request the technical specification and a quotation for this instrument.
Request a quoteCall usPDF catalogue
