Photographs have been adapted for the website; dimensions may vary.
EN 12310-1 Nail-Shank Tear Test Fixture
EN 12310-1 Çivi Gövdeli Yırtılma Test Aparatı
A fixture used with a tensile testing machine to assess the nail-shank tear resistance of bitumen sheets for roof waterproofing according to EN 12310-1. A specimen held by a nail shank is torn under tensile force. Fixture connection, specimen thickness and machine compatibility are confirmed in the order-specific technical specification.
Model technical data
- Instrument type: passive nail-shank tear fixture for bituminous roof waterproofing sheets.
- Reference-machine requirement: at least 2000 N load capacity and sufficient grip separation.
- Method speed: 100 ± 10 mm/min; reference grip width at least 100 mm.
- Stirrup, nail and connection geometry are defined by the fixture clause of the selected EN 12310-1 edition.
Physical specifications and utilities
| Electrical supply | Manual / passive base apparatus; no mains supply assumed. |
|---|---|
| Power / connected load | Approx. 0 W connected load for preliminary planning. |
| Overall instrument dimensions | Approx. 200 × 100 × 200 mm (W × D × H). |
| Instrument weight | Approx. 2–5 kg net. |
| Gross / shipping weight | Approx. 4.2–8.2 kg gross; estimated packing allowance. |
| Lab requirements | Separate tensile machine of suitable capacity and a compatible grip interface are required. |
Dimension order and approximate values are stated in each row. Packaging data are separate from instrument dimensions and net mass. Approx. rows are preliminary engineering estimates based on comparable equipment and function/capacity; they are not verified manufacturing measurements or standard requirements. Installation and shipment are finalised against the approved drawing and nameplate. Estimate scope: base product / one unit; external computer, bench and auxiliary plant excluded.
Specifications, dimensions, and power requirements are approximate and subject to change without prior notice for continuous design improvements.
Product technical specifications and images may vary according to manufacturing conditions and applicable standards.
Test and configuration
- Measured output / function
- Nail-shank tear force (N)
- Parameters selected for the method
- Test machine capacity, nail geometry and specimen direction
- Verification points
- Force, speed and fixture dimensions
Listed methods are application references. Suitability is established by assessing the selected hardware, current method and calibration together.
Test parameters for the reviewed method
Values belong to the stated source edition. Test recipe, fixture and delivered instrument configuration are selected together.
EN 12310-1:1999 / SIST EN 12310-1:2000 · 5.1-5.2, 8
- Bituminous-sheet nail tear fixture: reference tensile machine at least 2000 N, grip width at least 100 mm and speed 100 ± 10 mm/min. Nail diameter in the stirrup 2.5 ± 0.1 mm. Assess the passive fixture's electrical needs separately from the reference machine.
Control and recording specification
The following are method-specific software/recording requirements; delivered software modules are defined by the order scope.
- The need for integrated software depends on the method and selected hardware; manual instruments use an external test record.
- Method code and edition, specimen ID, operator and selected test parameters are linked to the record.
- The calculation and endpoint are defined by the selected method edition; instrument signals and operator assessments are kept distinct.
- Raw measurements, units, valid/invalid test flags and the reported result remain traceable.
- Calculations are checked against known inputs and an independent calculation; sensor channels are checked against calibration values.
Test standards
Prices start from €18. Request the technical specification and a quotation for this instrument.
Request a quoteCall usPDF catalogue
