Photographs have been adapted for the website; dimensions may vary.
Carpet Abrasion Machine (Schiefer)
Halı Aşındırma Makinesi (Schiefer)
Carpet pile abrasion resistance by Schiefer abrasion motion; mass loss is measured after a set number of rubs. Simulates long-term use of carpets and floor coverings as realistically as possible. Features a robust and durable mechanical structure.
Model technical data
- Operates with the Schiefer abrasion motion.
- Supplied with an electronic preset unit and cumulative counter.
- Fitted with an interlocked safety cover.
Functional schematic: illustrative only; not a production photograph or a dimensioned engineering drawing.
Physical specifications and utilities
| Electrical supply | Approx. 220–240 V AC, 50/60 Hz, single phase; build-dependent. |
|---|---|
| Power / connected load | Approx. 200–500 W connected load for preliminary planning. |
| Overall instrument dimensions | Approx. 700 × 600 × 800 mm (W × D × H). |
| Instrument weight | Approx. 60–100 kg net. |
| Gross / shipping weight | Approx. 91–150 kg gross; estimated packing allowance. |
| Lab requirements | Level, stable working surface; specimen conditioning follows the selected method. |
Dimension order and approximate values are stated in each row. Packaging data are separate from instrument dimensions and net mass. Approx. rows are preliminary engineering estimates based on comparable equipment and function/capacity; they are not verified manufacturing measurements or standard requirements. Installation and shipment are finalised against the approved drawing and nameplate. Estimate scope: base product / one unit; external computer, bench and auxiliary plant excluded.
Specifications, dimensions, and power requirements are approximate and subject to change without prior notice for continuous design improvements.
Product technical specifications and images may vary according to manufacturing conditions and applicable standards.
Test and configuration
- Measured output / function
- Change in mass, appearance or damage after abrasion
- Parameters selected for the method
- Abradant, load, motion, cycles and endpoint
- Verification points
- Motion, counter, load and condition of abradant
Listed methods are application references. Suitability is established by assessing the selected hardware, current method and calibration together.
Test parameters for the reviewed method
Values belong to the stated source edition. Test recipe, fixture and delivered instrument configuration are selected together.
EN 1813:1997 / GOST R EN 1813:2011 (IDT) — historical European method · 1; 4.1 Table 1 speed/axis spacing only; 4.4; 7.5
- 2011 IDT adoption of EN 1813:1997: holders 156 ± 3 rpm; axis spacing 25.4 ± 0.2 mm. Weighing error ±10 mg; basic test 5000 revolutions. For carpets with at least 80% wool pile. The adoption’s pressure unit could not be verified against the original, so no numerical pressure is specified here.
Control and recording specification
The following are method-specific software/recording requirements; delivered software modules are defined by the order scope.
- Method code and edition, specimen ID, operator and selected test parameters are linked to the record.
- The calculation and endpoint are defined by the selected method edition; instrument signals and operator assessments are kept distinct.
- Raw measurements, units, valid/invalid test flags and the reported result remain traceable.
- Calculations are checked against known inputs and an independent calculation; sensor channels are checked against calibration values.
Test standards
Prices start from €18. Request the technical specification and a quotation for this instrument.
Request a quoteCall usPDF catalogue
