Photographs have been adapted for the website; dimensions may vary.
Pile Wear / Abrasion Tester
Hav Aşınması Test Cihazı
Abrasion resistance of carpet pile. Simulates long-term use of carpets and floor coverings as realistically as possible. Features a robust and durable mechanical structure.
Model technical data
- Used to determine the wet and dry abrasion resistance of flexible materials such as textiles, paper, leather and plastics.
- Rotates the specimens inside a cylindrical test chamber lined with abrasive material.
- The rotating action is provided by a rotor-shaped impeller at a preset speed for a preset duration.
Functional schematic: illustrative only; not a production photograph or a dimensioned engineering drawing.
Physical specifications and utilities
| Electrical supply | Approx. 220–240 V AC, 50/60 Hz, single phase; build-dependent. |
|---|---|
| Power / connected load | Approx. 300–800 W connected load for preliminary planning. |
| Overall instrument dimensions | Approx. 650 × 550 × 800 mm (W × D × H). |
| Instrument weight | Approx. 40–80 kg net. |
| Gross / shipping weight | Approx. 69–125 kg gross; estimated packing allowance. |
| Lab requirements | Level, stable working surface; specimen conditioning follows the selected method. |
Dimension order and approximate values are stated in each row. Packaging data are separate from instrument dimensions and net mass. Approx. rows are preliminary engineering estimates based on comparable equipment and function/capacity; they are not verified manufacturing measurements or standard requirements. Installation and shipment are finalised against the approved drawing and nameplate. Estimate scope: base product / one unit; external computer, bench and auxiliary plant excluded.
Specifications, dimensions, and power requirements are approximate and subject to change without prior notice for continuous design improvements.
Product technical specifications and images may vary according to manufacturing conditions and applicable standards.
Test and configuration
- Measured output / function
- Change in mass, appearance or damage after abrasion
- Parameters selected for the method
- Abradant, load, motion, cycles and endpoint
- Verification points
- Motion, counter, load and condition of abradant
Listed methods are application references. Suitability is established by assessing the selected hardware, current method and calibration together.
Control and recording specification
The following are method-specific software/recording requirements; delivered software modules are defined by the order scope.
- Method code and edition, specimen ID, operator and selected test parameters are linked to the record.
- The calculation and endpoint are defined by the selected method edition; instrument signals and operator assessments are kept distinct.
- Raw measurements, units, valid/invalid test flags and the reported result remain traceable.
- Calculations are checked against known inputs and an independent calculation; sensor channels are checked against calibration values.
Prices start from €18. Request the technical specification and a quotation for this instrument.
Request a quoteCall usPDF catalogue
